How much is a rear axle bearing?

How much is a rear axle bearing?

As for the rear wheel bearings, they will be a tad cheaper to replace but this will of course depend on the car make and model. The cost of a complete rear wheel bearing replacement will be somewhere in area of $240 to $460. Parts will on average be between $100 and $180. The labor costs will be around $140 to $280.

How much is an axle bearing?

Axle Shaft Bearing Replacement Cost – RepairPal Estimate. Labor costs are estimated between $189 and $239 while parts are priced at $187.

What do bad rear wheel bearings sound like?

Most people describe a bad wheel bearing as making a growling or rumbling noise (the sound is often mistaken for worn tires). Also, in some cases, a bad bearing may make a high-pitched grinding or squealing sound. In either case, the frequency of the sound will correspond to the rotation of the tires.

Is it easy to replace wheel bearings?

Is it easy to replace a wheel bearing at home? Replacing a wheel bearing that comes as an assembly with the hub and bolts to the spindle or steering knuckle is not very difficult if you have proper skills, tools and the manual. Of course, the large axle nut is very tight and can be difficult to remove.

How to replace CV axle on Toyota Tacoma?

KenpachiZaraki[OP]Its Wicked Flow BITCHES!! Hey guys,I did this recently,took some pics,and i hope they help out.

  • JasoTaco Well-Known Member. Wow great write up!
  • KenpachiZaraki[OP]Its Wicked Flow BITCHES!!
  • MY50cal —- Tread Lightly —- Leave No Trace.
  • nobody4343 Well-Known Member
  • KenpachiZaraki[OP]Its Wicked Flow BITCHES!!
  • How much does it cost to replace rear axle bearings?

    Rear Wheel Bearings. On average, you can expect to pay between $190 and $310 for the parts associated with replacing your rear wheel bearings. The average labor costs will be between $225 and $350. Front Wheel Bearings. As for replacing your front wheel bearings, this service actually costs more.

    How to replace your axle seal and bearings DIY?

    Hammer

  • Needle-nose pliers
  • Parts cleaning brush
  • Slip joint pliers
  • How to replace rear axle seals and bearings?

    Heat your oven to 400° F and place the bearings and retaining collars in it. The heat will cause them to expand,easing installation a little later.

  • Park on a flat and level surface and block a front wheel.
  • Place the drain pan under the differential housing and remove the drain plug if there is one.