Is cedar easy to mill?

Is cedar easy to mill?

In total, I have milled hundreds of cedars logs and have learned a lot about them. Cedars are light, easy to cut and usually fairly small. I was excited to cut the cedars at Tyson because many were quite big. A few even maxed out the 30″ bar on my chainsaw when I felled them.

How long can cedar logs sit before milling?

From Gene Wengert, forum technical advisor: As a rule of thumb, there will be a measurable loss in four to six weeks of warm (over 50 F) weather. It is just a rule of thumb.

Can you mill cedar?

Milling. Cut your cedar logs into lengths that can be run through a mill saw to make boards. Since most projects are built from 3/4-inch thick stock, have your logs cut into 1-inch thick slabs, and the side cut square, so that you can rip them to size with a circular or table saw.

How long should a log dry before milling?

Depending on the thickness of the lumber and where you live, weather and time of the year, it will take anywhere from 6 weeks to 4 months. Most lumber is in the 1” to 2” thickness and the time above applies to thicknesses.

How do you prepare cedar logs?

Strip the bark off the cedar logs to prevent decay and to make way for a clear finish later. If you’re using cedar, you can usually strip most of the stringy bark by hand and follow up with a pressure washer for a cleaner result. You’ll reveal beautiful, natural imperfections at this point like worm tunnels and knots.

How long will cedar logs last on the ground?

In outdoor structures that are not in contact with the ground, such as decks, gazebos, pergolas and fence boards, cedar may last 30 years or longer. When in contact with the ground, such as when it’s used for fence or support posts, it can last between 15 and 20 years.

How do you process cedar logs?

This airflow method is basically a process of moisture evaporation, drying the cedar out over time by exposing it to air after cutting.

  1. Cut the cedar tree trunk into sections using a chain saw.
  2. Place the cedar logs in a cool, dry area with frequent airflow.
  3. Leave the cedar logs in place for 18 months to cure.

Who buys cedar logs?

PORT TOWNSEND — Trial dates have been set for two Forks men accused of cutting chunks of cedar logs from a state Department of Natural Resources bridge to sell on the black market. Jose Carmen Salinas, 42, and Troy Stephen Crandall, 62, are each charged

Where to buy cedar logs?

– Other Cedar timbers available Special Order – Incense Cedar timbers from 16’ to 32’ – Port Orford Cedar available from 20’ to 40’

How to saw logs into lumber?

Live Sawing. Live sawing,also known as slab sawing or through and through sawing,is when a log is sawn about halfway through on the opening face and then turned

  • Cant Sawing. With cant sawing,the first cuts are made across the top of the log and flipped 180 degrees to saw the second cuts across the opposite face.
  • Grade Sawing.
  • How to mill a log?

    Log Preparation Cut the logs to length The length is based on your lumber needs.

  • Stacking and Drying Rough Cut Green Lumber Let me say at the outset that drying of lumber is a science unto itself.
  • Stay Safe and Get Help