How much is a clutch for a 2004 Ford Ranger?
How much is a clutch for a 2004 Ford Ranger?
2004 Ford Ranger Clutch Set – from $128.99+ | AutoZone.com.
How much does it cost to replace a clutch in a Ford Ranger?
Ford Ranger Clutch Replacement Cost Estimate. Labor costs are estimated between $381 and $480 while parts are priced between $441 and $449. This range is based on the number and age of Ford Ranger’s on the road.
Is 2004 Ford Ranger a good car?
Edmunds’ Expert Review The 2004 Ford Ranger isn’t the freshest compact pickup on the market, but it’s still a solid choice thanks to a strong 4.0-liter V6 engine and a wide variety of equipment.
Does a Ford Ranger have a hydraulic clutch?
The hydraulic clutch on a Ford Ranger uses brake fluid to pressurize the clutch system and makes it easier to disengage the clutch from the transmission. Before doing any service work, you need to diagnose the hydraulic clutch on your Ford Ranger.
Can you replace clutch yourself?
If you are sure that your clutch has worn out beyond repair then you can potentially replace the clutch yourself at home. It is possible, but it is a relatively lengthy and complicated procedure. There are several fiddly steps where there is a wide scope for things to go wrong.
How many miles do 2004 Ford Rangers last?
Because, according to Motor and Wheels, you can count on the Ranger to last up to 300,000-miles.
How long will a 2004 Ford Ranger last?
How long do Ford Rangers last? The Ford Ranger can last up to 20 years with no major faults. Even though the truck is overshadowed by the F-150, the Ranger is solidly built and will push the 300k-mile threshold with little trouble.
How much is a clutch for a Ford Ranger?
Clutch Replacement Cost. The average cost for a Ford Ranger clutch replacement is between $832 and $938. Labor costs are estimated between $376 and $474 while parts are priced between $456 and $464. This range does not include taxes and fees, and does not factor in your specific model year or unique location. Related repairs may also be needed.
How to diagnose the hydraulic clutch on a Ford Ranger?
– still air in the line. Small chance but can try bleeding again – Bad slave. Would need to pull tranny (I am a mechanical engineer and whoever designed this should be punished) – Bad clutch??? Doesn’t seem like it should be though. – Any other ideas??? If I do have to pull the tranny, anything else I should do while I’m there from a reliability standpoint?
How to replace shocks on a Ford Ranger?
Verify that the shock absorbers are bad.
How to bleed a Ford Ranger clutch master cylinder?
Raise the Ford Ranger about 6 inches off the ground with a jack. You can drive the truck on ramps if you have them.