What psi do you use for orange peel texture?

Pressure of 25 to 45 PSI is usually perfect. Lower pressure won’t be sufficient to expel the compound from the gun; higher pressure will make it harder to control the application. A smaller aperture will create a finer texture, whereas a larger opening will cause bigger blobs to form.

Should drywall be primed before texturing?

The reason for priming new drywall before texturing is because the tape joints and nail spots are more absorbent than the surrounding drywall which results in the texture drying faster in those areas.

How do you use a texture Pro 200 sprayer?

Fill the Hopper of your TEXTURE-PRO@ 200 2/3 to 3/4 full with texture material. Starting in a corner along an edge, orient the TEXTURE-PRO@ 200 so the Spray Tip is 18″ below and pitched at a 45 degree angle to the surface being textured. Pull the trigger and move sideways until you reach the opposite corner or edge.

How do I clean the air cap on my airsoft gun?

c) Take off air cap and material orifice, clean orifice using a bamboo or wooden toothpick. Then wipe off air cap and orifice with a rag moistened with thinner. d) Reassemble orifice and screw air cap tight. a) Back up the gun, put a few drops of machine oil or replace with new O-ring.

How do you install an air compressor on a hopper gun?

FOR PISTON/TANK TYPE COMPRESSOR A.Thread the 90° brass elbow (I) onto the air inlet fitting (J) at the bottom of the hopper gun handle. B.Thread the air shut-off valve (F) onto the brass elbow. C.Thread the quick disconnect (G) onto the air shut-off valve.

How do I lubricate my Hopper gun?

Turn the hopper gun upside down and lubricate with household oil by dropping oil in the quick disconnect (with the air shut-off valve in the open position). This lubricates the air stem and O-rings. 4. Pull the trigger several time s and close the shut-off valve. ASSEMBLING AND DISASSEMBLING YOUR HOPPER GUN Taking Your Hopper Gun Apart 1.