What size pipe is used for a washer drain?

two inches
The required size for your washing machine drain pipe is two inches. The drain pipe must also have a P-trap that measures between six and 18 inches above the floor, and then a standpipe that measures between 18 and 30 inches above that.

How should a washing machine drain pipe be?

Smaller, compact washing machines are only able to pump water up around 5 feet. Your drain pipe needs to have an inside diameter of 1 ½ inch to ensure proper draining, with an outside diameter of 1 ¼ inch. You should also make sure that your drain pipe is at least 30 inches high to prevent potential water siphoning.

Can I drain my washing machine outside?

Most States it is illegal to dump greywater directly on the ground. Also, most States that allow the use of greywater, require that the system be designed and built by a licensed plumber certified by the State in Greywater treatment and disposal systemsl just any ole plumber will not due.

Can a washing machine drain line be 1 1 2?

Drain and Trap Requirements A 2-inch drain pipe is required for all washing machines. The former requirement of 1 1/2-inch pipe is not enough to handle the fast drainage of modern washers. Position the trap between 6 and 18 inches above the floor, with a standpipe of 18 to 30 inches above that.

Can I use 32mm waste pipe for washing machine?

32mm is perfectly fine for a washing machine, just think of the size of hose that comes attached to the machine itself!

How far down should a washer drain hose go?

In order for the drain hose on your Top Load washer to function properly, the drain must be at least 30″ up from the floor and less than 8 feet high. In order for the drain hose on your Front Load washer to function properly, the drain must be at least 24″ up from the floor and less than 8 feet high.

Does a washing machine waste pipe need a trap?

When hooking up a new washing machine, some people look for a convenient drain line and simply install a pipe that extends to the washer. The lack of a P-trap exposes the area to sewer fumes and the lack of venting will cause the drain to run sluggishly and overflow. Washers, like all fixtures, need a trap.

How do you divert water from a washing machine?

Run the washing machine’s discharge hose to the container. Water from your washing machine will flow into the container after each load of laundry. You can cut a hole in the container’s lid large enough to fit the hose. This will prevent water from splashing out of the open container.

How do you slow down a washing machine drain?

A solution to your problem is to put a restriction in your washing machine discharge hose to slow down its flow to what your drain can handle. Just don’t slow it down to the point that your washing machine timer times out and goes on to the next step in the cycle!